#Install additional ram for mac computer manual

While most laptop memory modules are installed individually, some must be installed in matched pairs, known as “banks.” The memory banks should be clearly labeled, but consult your owner's manual to be sure. If in place correctly, only a thin portion of the gold pins – 1/16th of an inch or less – should be visible (about the width of a line of pencil drawn on a piece of paper). Firmly push the module in at a 45° angle, then push down until the clips on the side of the slot snap into place.

Align the notches on the module with the ridges in the slot.

Maximize the performance of your system by filling each slot with high density modules. under the keyboard and under the back casing), so double-check your owner's manual to confirm the location of all memory slots on your system. Note: On laptops, there are often multiple locations for the memory slots (i.e.

Locate and access the memory slots on your laptop using your owner's manual.

To protect your new memory modules and your system's components from static damage during the installation process, touch any of the unpainted metal surfaces on your computer's frame before handling and installing memory.

Discharge residual power by pressing and holding the power button for 3-5 seconds.Once your system has been powered off, unplug the power cable, then remove the battery. Remove any plastic bags or papers from your workspace. Make sure you are working in a static-safe environment.Laptop installation process (for SODIMM modules)

#Install additional ram for mac computer install

To install memory in a Mac workstation, follow the desktop installation instructions below. To install memory in a Mac system, follow the laptop installation instructions below, or consult our library of system-specific Mac install guides on. laptop or desktop), almost all Mac systems use laptop memory (SODIMMs). Avoid touching the components and gold pin connectors as damage can occur. When handling memory modules, be sure to hold them along the side edges using your thumb and index finger.Either method will safely discharge static electricity that's naturally present in your body. To protect your system's components from static damage during the installation process, touch any of the unpainted metal surfaces on your computer's frame or wear an ESD wrist strap before handling internal components. Static electricity can damage the components in your system.Non-magnetic-tip screwdriver (for removing the cover on your computer).